Table of Contents
Advertisement
@GEC / @SEC
Getting
Command
example
Response
Description
Setting
Command
example
Response
Description
Remarks
Up to 32 commnads can be specified by separating them by a comma.
If you send only parameters of reply command number you want to check, the
reply commands without sent parameter are automatically set to "not check".
Register reply commands in "@GRC / @SRC Response command".
Control command (Communication command) (cont'd)
@GEC,1
@GEC,1,10,1,POWER,7,5057204F4E0D0A,1000,2,500,0,0,1,2
Getting settings registered in control command 1.
・Delay: 10 ms
・Output port: RS-232C connector
・Memo: POWER
・Data size: 7 bytes
・Command data: PW ON CR LF (ASCII codes)
・Timeout: 1000 ms
・Retry: 2 times
・Retry interval: 500 ms
・Retry over: Stop
・Received data: Not displayed
・Response command: Check 1 and 2
@SEC,2,0,1024,IN1 SELECT,10,405353572C312C310D0A,0,0,0,1,0
@SEC,2,0,1024,IN1 SELECT,10,405353572C312C310D0A,0,0,0,1,0
Setting control command 2 as follows:
・Delay: 0 ms
・Output port: LOOP BACK
・Memo: IN1 SELECT
・Data size: 10 bytes
・Command data: @SSW,1,1 CR LF (ASCII codes)
・Timeout: 0 ms
・Retry: 0 time
・Interval: 0 ms
・Retry over: Execute
・Received data: Not displayed
・Response command: Not checked
－
MSD-62 series Command Guide
87
Advertisement
Table of Contents
