Table of Contents
Advertisement
@GSS
I/O status (cont'd)
Parameter
*5
Type of output signal.
*6
Error codes below are returned in the following order: video output to HDMI output
Reply
example
Hxx
HDMI signal is output. xx stands for the color depth, 24 or 30.
D
DVI signal is input.
HDCP is being authorized. No video is output.
C
N
No sink device is connected.
O
No twisted pair cable is connected.
connector / audio output to HDMI output connector / audio output to audio output
connector.
Error code
Video output status
Video or audio is output correctly.
0
－
1
2
Only digital input is returned, which means DDC power is not
input. (When no source device is connected, this error code is
normally displayed.)
3
No video signal is input.
4
Only digital input is returned, which means video or audio output of
the source device is muted.
5
Only digital input is returned, which means signal with HDCP is
input but sink device is HDCP incompliant (This error code may be
also returned during HDCP authentication)
6
Only digital input is returned, which means source device does not
output the returned information (packets) for output of video or
audio.
Signal that is not supported by
7
MSD series (dot clock is out of
range) is input.
－
8
－
9
MSD-62 series Command Guide
Type of output signal
Audio output status
*7
"@GAM / @SAM Audio output
mute" is set to "ON".
No audio signal is input.
Since compressed audio is
input, audio cannot be output
(Compressed audio can be
output only to sink devices
supporting compressed audio).
－
"@GDM / @SDM Output mode"
is set to "DVI MODE" or a sink
device that does not support
audio is connected.
*7
*8
117
Advertisement
Table of Contents
