Setting Up Rs-232C Communication - IDK MSD-72 Series Command Reference Manual

MSD-72 series Command Guide

2.1.3 Setting up RS-232C communication

(1) Connect the MSD and the control device via an RS-232C cable.
(2) Set the RS-232C communication as follows:
・RS-232C communication: baud rate, data bit length, parity check, and stop bit
・Operation mode of RS-232C communication: "RECEIVER"
(3) For the control device, set the same values in the same way as RS-232C communication (baud rate, data
bit length, parity check, and stop bit) in step (2) above.
(4) Send a communication command from the control device to the MSD in order to check the control status of
the MSD.
Step (3)
Step (1)
RS-232C cable
Laptop
(Controller)
Operation example of RS-232C communication
Laptop
Power amplifier
8
Step (4)
Communication
command
[Figure 2.3] Setting RS-232C communication
Controlling the MSD using
Communication commands
RS-232C cable
Controlling the MSD using Outputting control commands
Communication commands
[Figure 2.4] RS-232C communication
RS-232C cable
to external device
【Reference: User's Guide】
Step (2)
Projector