Table of Contents
Advertisement
4.
Pull back the spring-loaded probe retaining knob (located on the probe
insertion lock).
Caution:
• Ensure the probe tip is not knocked during removal, as it is
• To avoid damage to the probe filament, do not pass a current
5.
Withdraw the probe from the probe insertion lock.
Controlling the DCI probe current
Ramping the probe current manually
To ramp the probe temperature manually:
1.
In the MassLynx Tune window Inlet tab, select Use DCI mode.
2.
Enter the required current in the DCI Probe text box. The ramp range is
0 to 1.6 A.
easily damaged.
through the probe tip when the tip is in air.
Controlling the DCI probe current
8-7
Advertisement
Table of Contents
Troubleshooting
