Using Calibrations For Subsequent Acquisitions; Using Calibrations; Associating A Calibration File With An Acquisition - Waters GCT Premier Operator's Manual

Using calibrations for subsequent acquisitions

Using calibrations

When acquiring data via the Tune window or from the Sample List, the last
calibration file produced using the calibration wizard or manually produced
calibration can be used. The calibration file that is currently being used is
displayed on the Tune window Calibration tab. The calibration file should
have been acquired using the same Engineer tab parameters and TDC
Settings in the Tune window that were used to create the .ipr instrument
parameter file used during the MS experiment.

Associating a calibration file with an acquisition

In the Tune window you can select a calibration file that will be used for
subsequent acquisitions from both the Tune window and the MS Method
window.
To associate a calibration file with an acquisition:
1. In the Tune window, click the Calibration tab.
Calibration tab:
2. Click Open Calibration.
3. In the Open dialog box, select the required calibration file (*.cal).
4. Click Open.
Using calibrations for subsequent acquisitions 5-15