Hdmi Video Output - Xilinx ZC706 User Manual

Table 1-21: USB Connector J21 Pin Assignments and Signal Definitions
USB Connector (J21)
Pin Name
1 VBUS USB_UART_VBUS
2 D_N USB_UART_D_N
3 D_P USB_UART_D_P
5 GND USB_UART_GND
Table 1-22 lists the USB connections between the XC7Z045 AP SoC PS Bank 501 and the
CP2103 UART bridge.
Table 1-22: XC7Z045 AP SoC to CP2103 Connections
XC7045 AP SoC (U1)
Pin Name Bank PIN Function Direction IOSTANDARD
PS_MIO48 501 C19
PS_MIO49 501 D18
Refer to the Silicon Labs website for technical information on the CP2103GM and the VCP
drivers [Ref 21].
For additional information on the Zynq-7000 AP SoC device UART controller, see Zynq-7000
All Programmable SoC Overview (DS190) and Zynq-7000 All Programmable SoC Technical
Reference Manual (UG585).

HDMI Video Output

[Figure 1-2, callout 18]
The ZC706 evaluation board provides a high-definition multimedia interface (HDMI®)
video output using an Analog Devices ADV7511KSTZ-P HDMI transmitter at U53. The HDMI
transmitter U53 is connected to the XC7Z045 AP SoC PL-side banks 12 and 13 and its output
is provided on a Molex 500254-1927 HDMI type-A receptacle at P1. The ADV7511 supports
1080P 60Hz, YCbCr 4:4:4 encoding via 24-bit input data mapping.
The ZC706 evaluation board supports the following HDMI device interfaces:
• 24 data lines
• Independent VSYNC, HSYNC
• Single-ended input CLK
• Interrupt Out pin to XC7Z045 AP SoC
ZC706 Evaluation Board User Guide
UG954 (v1.5) September 10, 2015
Net Name
+5V VBUS Powered
Bidirectional differential serial data (N-side)
Bidirectional differential serial data (P-side)
Signal ground
TX Output LVCMOS18
RX Input LVCMOS18
www.xilinx.com
Description
CP2103GM Device (U52)
Schematic Net
Name
PIN Function Direction
USB_UART_RX 24
USB_UART_TX 25
Feature Descriptions
CP2103GM (U52)
Pin Name
7 REGIN
8 VBUS
4 D –
3 D +
2 GND1
29 CNR_GND
RXD Input
TXD Output
50
Send Feedback