Hdmi Video Output - Xilinx VC707 User Manual

Table 1-19: USB Connector J17 Pin Assignments and Signal Definitions
USB Connector (J17)
Pin Name
1 VBUS USB_UART_VBUS
2 D_N USB_D_N
3 D_P USB_D_P
4 GND USB_UART_GND
Table 1-20
Table 1-20: FPGA to UART Connections
Refer to the Silicon Labs website for technical information on the CP2103GM and the VCP
drivers

HDMI Video Output

[Figure
The VC707 board provides a High-Definition Multimedia Interface (HDMI™) video
output using the Analog Devices ADV7511KSTZ-P HDMI transmitter (U48). The HDMI
output is provided on a Molex 500254-1927 HDMI type-A connector (P2). The ADV7511 is
wired to support 1080P 60 Hz YCbCr and RGB video modes through 36-bit input data
mapping.
The VC707 board supports the following HDMI device interfaces:
•
•
•
•
•
•
VC707 Evaluation Board
UG885 (v1.2) February 1, 2013
Net Name
+5V VBUS Powered
Bidirectional differential serial data (N-side)
Bidirectional differential serial data (P-side)
Signal ground
shows the USB connections between the FPGA and the UART.
FPGA (U1)
Pin UART Function
AT32 RTS, output
AR34 CTS, input
AU33 TX, data out
AU36 RX, data in
[Ref 4].
1-2, callout 18]
36 data lines
Independent VSYNC, HSYNC
Single-ended input CLK
Interrupt Out Pin to FPGA
2
I C
SPDIF
www.xilinx.com
Description
CP2103GM UART (U12)
Net Name
Pin
USB_CTS 22
USB_RTS 23
USB_RX 24
USB_TX 25
Feature Descriptions
CP2103GM (U44)
Pin Name
7 REGIN
8 VBUS
4 D –
3 D +
2 GND1
29 CNR_GND
UART Function
CTS, input
RTS, output
RXD, data in
TXD, data out
39