Appendix A: Default Switch And Jumper Settings; Switches - Xilinx ZC706 User Manual

Default Switch and Jumper Settings
The default switch and jumper settings for the ZC706 evaluation board are provided in this
appendix.

Switches

[Figure 1-2, callout 24]
Default switch settings are listed in
called out in Table A-2
Table A-1: Default Switch Settings
Switch
SW1 Board main power On-Off Slide Switch
SW4 2-pole SPST DIP Switch, JTAG mode select
signals JTAG_SEL_[1:2]
SW11 5-pole DPDT DIP Switch, PS Boot Mode select
signals MIO[6:2]_SELECT
SW12 4-pole SPST DIP Switch, user signals
GPIO_DIP_SW[0:3], poles [1:4]
ZC706 Evaluation Board User Guide
UG954 (v1.5) September 10, 2015
Table
are shown in Figure
Function
www.xilinx.com
A-1. The locations of the ZC706 jumper headers
A-1.
Default
OFF Delivered in OFF position
JTAG = cable connector J3
10
All Down JTAG flat cable header J3
All OFF All = 0 (4.7K p/d to GND)
Appendix A
Figure 1-2
Selects
Callout
27
34
29
24
Send Feedback
86