Carriage Assembly; Carriage Assembly Removal Procedure - Qualstar RLS-8350 Technical & Service Manual

7.10 Carriage Assembly

P/N 510750-01-1
P/N 510750-02-9
The Carriage Assembly contains the Handler, which moves front to back and vertically
within the library while carrying the Gripper Assembly with the barcode reader. The Grip-
per Assembly grasps the tape cartridges and moves fore and aft to insert or remove tape
cartridges.
Tools Required:
No. 2 Phillips Screwdriver
•
Carriage
Assembly
Figure 7-8 Carriage Assembly shown with the User Interface Panel Assembly removed

7.10.1 Carriage Assembly Removal Procedure

Remove power from the RLS by first pressing the power switch on the rear of the
1.
library off and then removing the power cord (two power cords if dual-redundant
power supply modules are installed).
Follow the steps in Section 7.11.1 to first remove the User Interface Panel As-
2.
sembly to access the Carriage Assembly.
7-12
RLS-85XX
RLS-8350
2 Screws securing the
Carriage Assembly to the RLS
(the lower/larger pair)
Field–Replaceable Units (FRUs)
511010 Rev. 07-01-19