Carriage Assembly Replacement; User Interface Panel Assembly - Qualstar RLS-8350 Technical & Service Manual

7.10.2 Carriage Assembly Replacement

This procedure assumes that the Carriage Assembly was removed in Section 7.7.1.
If the Carriage Assembly is replaced with a different Carriage Assembly, then the li-
brary will require re-calibration. See section 7.17.
Carefully align the Carriage Assembly with the RLS and slowly slide it in mak-
1.
ing sure that the System connector cable clears the 10U Z Satellite PCBA as the
Carriage Assembly slides to the rear of the RLS.
Carefully finish sliding the Carriage Assembly until the two guide pins connect
2.
with their corresponding holes.
Use a No. 2 Phillips screwdriver to replace the two screws that were removed
3.
earlier. See Figure 7-10.
Reach into the RLS to the right side of the Carriage Assembly and carefully re-
4.
connect the System connector to the 10U Z Satellite PCBA.

7.11 User Interface Panel Assembly

P/N 510752-01-7
P/N 510752-02-5
Tools Required:
No. 2 Phillips Screwdriver
•
Figure 7-11 User Interface Panel Assembly shown with Storage Matrices Removed
7-14
RLS-85XX
RLS-8350
Top 2 Screws
Sheet Metal
Cable Guard
Bottom 2 Screws
Field–Replaceable Units (FRUs)
511010 Rev. 07-01-19