Snmp Target Host Commands - Edge-Core ECS4210-12P Reference Manual

Chapter 5
| SNMP Commands

SNMP Target Host Commands

SNMP Target Host Commands
snmp-server enable
traps
This command enables this device to send Simple Network Management Protocol
traps or informs (i.e., SNMP notifications). Use the no form to disable SNMP
notifications.
Syntax
[no] snmp-server enable traps [authentication | link-up-down]
authentication - Keyword to issue authentication failure notifications.
link-up-down - Keyword to issue link-up or link-down notifications.
Default Setting
Issue authentication and link-up-down traps.
Command Mode
Global Configuration
Command Usage
◆
If you do not enter an snmp-server enable traps command, no notifications
controlled by this command are sent. In order to configure this device to send
SNMP notifications, you must enter at least one snmp-server enable traps
command. If you enter the command with no keywords, both authentication
and link-up-down notifications are enabled. If you enter the command with a
keyword, only the notification type related to that keyword is enabled.
◆
The snmp-server enable traps command is used in conjunction with the
snmp-server host command. Use the
which host or hosts receive SNMP notifications. In order to send notifications,
you must configure at least one
◆
The authentication, link-up, and link-down traps are legacy notifications, and
therefore when used for SNMP Version 3 hosts, they must be enabled in
conjunction with the corresponding entries in the Notify View assigned by the
snmp-server group
Example
Console(config)#snmp-server enable traps link-up-down
Console(config)#
Related Commands
snmp-server host (157)
snmp-server host
snmp-server host
command.
– 156 –
command to specify
command.