Ekip Power Controller; Presentation; Trip Units; Parameters On The Display - ABB SACE Emax E1.2 Operating Instructions For The Design Engineer

23 - Ekip Power Controller

Presentation The Ekip Power Controller function allows you to manage the load of an installation according to the power
trip units The function Power Controller can be activated for all the trip units of the Ekip TOUCH range, and allows you
Parameters on the display The parameters available following the path Main page - Menu page - Settings - Power Controller are:
Measurements on the display The measurements are available by following the path Main page - Measurements page - Power Controller
Information displayed Information about the state of the loads is available by following the path Main page - Menu page - Information
131 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
input, in order to contain consumption and to optimize energy efficiency.
The various parameters related to this function can be configured using a dedicated tool in the Ekip Connect
software.
For further information see the chapter "2 - Load control" on page 159.
to do the following via display:
• Modify some parameters of the function.
• Display some measurements of the function.
• View the state of the loads.
NOTE: the Power Controller function is available if requested when ordering the CB or the
protection trip unit.
Parameter Description
Enable It allows you to enable/disable the Power Controller function.
Load Operating It allows you to set the configuration of each of the 15 programmable loads
Mode Automatic or Manual configurations available.
Power limits It allows you to set the four power limits (from 0 to 10000 kW, step 10kW).
NOTE: for the characterization of all the parameters of the function you are advised to configure
the parameters via Ekip Connect first, and only subsequently to operate on the trip unit in
order to enable or to modify loads and power limits.
page, they are:
Measurement Description
Ea Expected energy
DT Time elapsed inside of the evaluation range
LOADS Number of loads monitored
LOADS Shed Number of shed loads
Sp Shed priority set
T Evaluation window
- Power Controller.
ABB | SACE Emax 2
Ekip Touch protection trip unit | 23 - Ekip Power Controller