ABB SACE Emax E1.2 Operating Instructions For The Design Engineer page 204

198 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
Continued from the previous page
Circuit-breaker
Main frequency
Modules
Settings
Power Controller
...
System
Functions
Maintenance
The following table describes the programmable actions on the trip unit:
Action Description
Trip RESET Resetting of the trip signal.
Resetting of the energy counters (see the chapter "16 - Ekip Measuring
RESET Energy
Measurements", and the paragraph "Energy counters", on page 113).
Opening of the circuit-breaker (see the chapter "6 - Menu", and the paragraph
External Trip
"Advanced menus", on page 48).
Switching of the connection from remote to local (see the chapter "6 - Menu",
Switch On LOCAL
and the paragraph "Settings Menu", on page 49).
Signalling RESET Resetting of the signals.
Opening coil command (see the chapter "6 - Menu", and the paragraph
YO Command
"Settings Menu", on page 49).
Closing coil command (see the chapter "6 - Menu", and the paragraph
YC Command
"Settings Menu", on page 49).
Switching the protections from configuration A to configuration B (see the
Turn on SET B
chapter "11 - Hi-Touch protections", and the paragraph "Set A-B", on page 87).
The following table shows the path for accessing the Test command of the module:
...
Test CB
Test
Ekip Signalling 2K
Ekip Signalling 4K
Zone selectivity (68)
(1)
Menu available with module Ekip signalling 2K.
...
Ground protection
Installation
...
Functions
YO Command
YC Command
(1)
Auto Test
Electronic accessories | 5 - Ekip Signalling 4K module
ABB | SACE Emax 2
Switch On LOCAL
Signalling RESET