ABB SACE Emax E1.2 Operating Instructions For The Design Engineer page 229

223 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
Continued from the previous page
The following table shows the path from the display for accessing information on the modules:
Protection Unit
Circuit-breaker
About
Modules
Power Controller
Information that can be displayed on the modules:
• The serial number and the software version.
• The IP address, the Network Mask, and the Gateway Address.
• TCP Clients.
• The MAC Address.
The following table shows the information on the modules:
Information Description
This is the address assigned to the modules at the moment of connection to the
network. It consists of four bytes (for a total of 32 bits), each of which can have a
value from 0 to 255.
By default, allocation is dynamic. With dynamic allocation, the modules wait to receive
the IP address from a DHCP server.
IP Address Without a DHCP server, the modules adopt an Autoconfiguration IP Address in the
range 169.254.xxx.xxx, calculated in a pseudo random manner so as to be the same
at every switch-on.
As an alternative, you can enable the static IP address option, which allows the IP
address to be forced. In this case, you must make sure that the IP Address inserted is
different from that of the other devices connected to the same network.
This is the subnet mask, and identifies the method to recognize the subnet to which
the modules belong, with the possibility of searching for the modules within a defined
Network Mask set of recipients.
If you enable the option Static IP Address, you must also enter the correct Network
Mask.
It is the IP address of the node to which the modules are connected, in case of
multiple subnets.
Gateway Address
If you enable the Static IP Address option, you must also enter the correct Gateway
Address.
TCP Client There are three IP Addresses of the client devices connected to the modules.
MAC Address It is the address assigned by ABB, having an OUI equal to ac:d3:64
(1)
Organizationally Unique Identifier, formed by the first three bytes of a MAC address, and which uniquely
identifies the manufacturer of an Ethernet device.
...
Ekip Com Modbus TCP
Ekip Com Modbus TCP *R
...
(1)
Electronic accessories | 10 - Ekip Com Modbus TCP modules
ABB | SACE Emax 2
.