ABB SACE Emax E1.2 Operating Instructions For The Design Engineer page 212

206 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
Continued from the previous page
The following table describes the programmable actions on the trip unit:
Action Description
Trip RESET Resetting of the trip signal.
Resetting of the energy counters (see the chapter "16 - Ekip Measuring
RESET Energy
Measurements", and the paragraph "Energy counters", on page 113).
Opening of the circuit-breaker (see the chapter "6 - Menu", and the paragraph
External Trip
"Advanced menus", on page 48).
Switching of the connection from remote to local (see the chapter "6 - Menu", and
Switch On LOCAL
the paragraph "Settings Menu", on page 49).
Signalling RESET Resetting of the signals.
Opening coil command (see the chapter "6 - Menu", and the paragraph "Settings
YO Command
Menu", on page 49).
Closing coil command (see the chapter "6 - Menu", and the paragraph "Settings
YC Command
Menu", on page 49).
Switching the protections from configuration A to configuration B (see the chapter
Turn on SET B
"11 - Hi-Touch protections", and the paragraph "Set A-B", on page 87).
The following table shows the path for accessing the Test command of the module:
...
Test CB
Test
Ekip Signalling 2K
Ekip Signalling 4K
Zone selectivity (68)
(1)
Menu available with module Ekip signalling 4K.
Auto Test
(1)
Electronic accessories | 6 - Ekip Signalling 2K modules
ABB | SACE Emax 2