Access From The Display - ABB SACE Emax E1.2 Operating Instructions For The Design Engineer

Access from the display With the modules energized, and the Local Bus enabled, the presence of the modules on the terminal box
211 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
activates additional menus on the display.
To enable the Local Bus, you need to select "On" in the menu Settings - Modules - Local Bus.
The following table shows the path for accessing the configuration parameters of the modules from the
display:
...
Main frequency
Settings
Modules
Power Controller
...
(1)
As Ekip Com Modbus RTU.
The following table shows the configuration parameters of the modules:
Parameter Values Default
• Ekip Com Modbus
Serial RTU: 247
1... 247
address • Ekip Com Modbus
RTU Redundant: 246
9600 bit/s,
Baudrate 19200 bit/s, 19200 bit/s
38400 bit/s
Physical 8.E,1, 8.O,1,
8,E,1
protocol 8.N,2, 8.N,1
NOTE: the modules can also be configured with the Ekip Connect software (see the chapter
"16 - Other accessories", and the paragraph "Ekip Connect software" on page 245).
The following table shows the path from the display for accessing information on the modules:
Protection Unit
Circuit-breaker
About
Modules
Power Controller
The information on the modules that can be displayed includes the serial number and the software version.
Local/Remote
Local Bus
...
Ekip Com Modbus RTU
Ekip Com Modbus RTU *R
...
Functions
Description
Address to be assigned to the modules.
IMPORTANT: devices connected to
the same network must have different
addresses.
Data transmission speed
• 8.E,1 = 8 data bits, 1 EVEN parity bit, 1 STOP bit.
• 8.O,1 = 8 data bits, 1 ODD parity bit, 1 STOP bit.
• 8.N,2 = 8 data bits, no parity bit, 2 STOP bits.
• 8.N,1 = 8 data bits, no parity bit, 1 STOP bit.
...
Ekip Com Modbus RTU
Ekip Com Modbus RTU *R
...
Electronic accessories | 7 - Ekip Com Modbus RTU modules
ABB | SACE Emax 2
Serial address
Baudrate
Physical
protocol
(1)