Start Page; Navigation - ABB SACE Emax E1.2 Operating Instructions For The Design Engineer

Start page To open the page, press the HOME key until the page is displayed.
Navigation The following table shows how to access the pages through the keys:
40 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
The system returns automatically to this page after some minute of inactivity.
The default start page is the Histograms page.
Any graphical level 2 page (accessible from the main page) can be set as the start page, except for the
pages Alarm List and Menu.
To set a page as the start page, you need to:
1. Open the page
2. Keep the HOME key pressed for at least 5 seconds.
3. Select Yes in the confirmation window that appears on the display.
To open...
The main page
The start page
The Alarm List page
The Info page
(1)
The Info page displays five lines of twenty characters each containing alphanumeric data that the customer
can insert through the Ekip Connect software (see the chapter "16 - Other accessories", and the paragraph "
Ekip Connect software" on page 245). To be displayed, it must be enabled (see the chapter "6 - Menu", and
the paragraph "Settings Menu" on page 49).
Perform these operations...
Press the HOME key.
Press the HOME key, until the start page appears.
If there are messages present, if the diagnostics bar is displayed:
• Touch the display in the message display area, or
• Press the iTEST button.
Press the iTEST key, until the Info page appears.
(1)
Ekip Touch protection trip unit | 1 - Layout of the interface
ABB | SACE Emax 2