Access From The Display - ABB SACE Emax E1.2 Operating Instructions For The Design Engineer

Access from the display To configure the module the trip unit must be on.
195 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
Then, the presence of the module activates the additional menus on the display:
• In order to configure the input and output contacts.
• To display information on the module and the state of inputs and outputs.
The following table shows the path for accessing the configuration parameters of the module from the display:
...
Main frequency
Settings
Modules
Power Controller
...
(1)
As the menu I 01.
(2)
As the menu O 01.
NOTE: the module can also be configured through the Ekip Connect software (see the chapter
"16 - Other accessories", and the paragraph "Ekip Connect software" on page 245).
The following table shows the configuration parameters of the inputs:
Parameter Selectable values
Polarity Active open, Active closed
0.00...100.00 s
Delay
steps of 0.01 s
Local/Remote
Local Bus
...
I 01
I 02
I 03
I 04
Ekip Signalling 4K
O 01
O 02
O 03
O 04
...
Functions
Default Description
• Active open = To be considered active,
the input must be floating.
Active
• Active closed = To be considered
closed
active, the input must be connected to its
reference.
Delay time after the input is activated
before the change of state is recognized
(if the input is reset before a time equal to
0.1 s the delay has elapsed, the change of state
is not recognized). If 0.00 s is selected,
the value 300 μs is assigned to the
parameter.
Electronic accessories | 5 - Ekip Signalling 4K module
ABB | SACE Emax 2
Polarity
Delay
(1)
(1)
(1)
Signal source
Delay
Contact type
Self-latching
Min activation time
(2)
(2)
(2)
Continued on the next page