Ekip Signalling 10K Modules; Ekip Signalling Modbus Tcp - ABB SACE Emax E1.2 Operating Instructions For The Design Engineer

Ekip Signalling 10K modules The Ekip Signalling 10K is an accessory module for external signaling that can be installed on a standard 35
Ekip Signalling Modbus TCP The Ekip Signalling Modbus TCP is an external accessory module that can be installed on a standard 35 mm
247 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
mm DIN rail (DIN EN 50022 type TS 35x15 mm).
This module has:
• Ten programmable output contacts.
• Ten or eleven programmable digital inputs.
• A power-on LED, and twenty or twenty-one signalling LEDs (one for each output/input).
The module can be set-up in four different configurations:
• One in case of connection to a Link bus network.
• Three configurations in case of connection via Local Bus (to allow up to three modules to be connected
to the same trip unit).
The module can be supplied by 110...240 V AC / DC or 24...48 V DC.
Further information on Ekip Signalling 10K is available on the website http://www.abb.com/abblibrary/
DownloadCenter/, in particular in the manual 1SDH001318r0002.
IMPORTANT: make sure that you have read the recommendations concerning security
and prevention from unauthorized access.
DIN rail (DIN EN 50022 type TS 35 x 15 mm).
Its function is to share, via an Ethernet network with Modbus TCP communication protocol, information about
the state of circuit-breakers that may even be without the capability to provide such information via Ethernet,
and to allow these circuit-breakers to be operated via remote control.
The module has 11 digital inputs and 10 output contacts:
• The inputs allow the state of the circuit-breakers and other information to be monitored.
• The outputs allow the circuit-breakers to be operated.
Each input and output is associated with a state LED.
The module can operate in three modes:
Mode
CB Supervisor
Multi MCCB Supervisor
Free I/O
The module can be supplied by 110...240 V AC / DC or 24...48 V DC.
Further details about Ekip Signalling Modbus TCP are available on the website http://www.abb.com/
abblibrary/ DownloadCenter/, in particular in the manual 1SDH001456r0002.
Characteristics
The module can be associated with a single circuit-breaker, which can be
selected from a list. Configuration of the inputs and output is pre-defined.
The module can be associated with up to five circuit-breakers.
Configuration of the inputs and output is pre-defined.
NOTE: mode available with moulded case circuit-breakers.
The inputs and outputs can be fully configured by the user.
ABB | SACE Emax 2
Electronic accessories | 16 - Other accessories