Test Menu - ABB SACE Emax E1.2 Operating Instructions For The Design Engineer

Test Menu This menu allows you to access the commands in order to perform the tests.
50 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
Continued from the previous page
Options
Settings
• Enable: it opens the Modify Parameters page, to enable/disable dual configuration
of the protections.
Dual Set
• Default Set: available with Dual Set enabled, it opens the Modify Parameters page,
to set the default configuration.
• Date: it opens the Modify Parameters page, to set the date.
• Time: it opens the Modify Parameters page, to set the time
System
• Language: it opens the Modify Parameters page, to set the language.
• New Password: it opens the page for insertion of the password.
• TFT orientation: it opens the Modify Parameters page to set the orientation of
the Alarm List and Measuring instruments pages, and with a summary of the
measurements accessible from the Histograms page.
• Ammeter Phase: it opens the Modify Parameters page to set the current the
View measurement of which is to be displayed in the Measuring instruments page.
• Voltmeter phase: it opens the Modify Parameters page to set the phase-to-phase
voltage the measurement of which is to be displayed in the Measuring instruments
page.
• Clients page: it opens the Modify Parameters page, to enable the Info
• YO Command: opens the list of parameters that can be set for programming the coil
opening command.
Functions
• YC Command: opens the list of parameters that can be set for programming the coil
closing command.
• Signals: it opens the Modify Parameters page, in order to enable/disable the
Maintenance
maintenance required signal, after a year from the last maintenance, or with contact
wear of at least 20 % and an increase of 10 % compared to the last maintenance.
(1)
The options in the Modules submenu change according to the electronic accessories connected.
(2)
Function available with the trip unit energized with auxiliary voltage.
(3)
Setting available with Hi-Touch and G Hi-Touch trip units.
(4)
If enabled, the Info page can be accessed by pressing the iTEST key until it appears; it displays five lines of
twenty characters each containing alphanumeric data that the customer can insert through the Ekip Connect
software (see the chapter "16 - Other accessories", and the paragraph "Ekip Connect software" on page 245).
The following table shows the submenus and the commands associated to the menus Test, up to Level
3 (if present). The options corresponding to commands are underlined, to distinguish them from those
corresponding to submenus.
Option
Test
Rc Test Test protection Rc.
(1)
Auto Test It performs a test on the display and LEDs of the interface.
Trip Test it enables the opening command.
• Close CB: it commands the closing of the circuit-breaker.
Test CB
• Open CB: it commands the opening of the circuit-breaker.
Ekip Signalling 2K • Auto Test
(2)
Ekip Signalling 4K • Auto Test
(2)
• S Protection: opens a list of the test commands of the Zone Selectivity
function for S protection.
Zone selectivity (68)
• G Protection: it opens a list of the test commands of the Zone Selectivity
function for G protection.
(1)
Test available with Rating Plug Rc and Ekip Measuring Pro modules, and toroid Rc (see Settings - Circuit
Breaker - Earth protection menu).
(2)
These menus are available if the relevant modules are connected.
ABB | SACE Emax 2
page.
(4)
Ekip Touch protection trip unit | 6 - Menu