Access From The Display - ABB SACE Emax E1.2 Operating Instructions For The Design Engineer

Access from the display With the module energized, and the Local Bus enabled, the presence of the module itself on the terminal box
240 | © 2017 ABB | 1SDH001330R0002 - ECN000058721 Rev. A
activates additional menus on the display:
• To set the addressing of the module.
• To display information on the module.
To enable the Local Bus, you need to select "On" in the menu Settings - Modules - Local Bus.
The following table shows the path from the display to set the addressing of the module:
...
Main frequency
Settings
Modules
Power Controller
...
The following table shows the configuration parameters for the addressing of the module: For further
information, see the table on page 241.
Parameter Selectable values
Force Static IP
Off, On
address
Displayed with static IP Address enabled, it must be selected in order to insert the
Static IP Address
IP Address of the module.
Displayed with static IP Address enabled, it must be selected in order to insert the
Static Network Mask
subnet mask of the module.
Displayed with static IP Address enabled, it must be selected in the presence
Static Gateway addr of multiple subnets, in order to insert the IP Address of the node to which the
module is connected.
The following table shows the path from the display for accessing information on the module:
Protection Unit
Circuit-breaker
About
Modules
Power Controller
Local/Remote
Local Bus
...
Ekip Link
...
Functions
Default Description
• Off = Dynamic IP address.
Off
• On = Static IP address.
Electronic accessories | 14 - Ekip Link module
ABB | SACE Emax 2
Force Static IP address
Static IP Address
Static Network Mask
Static Gateway addr
...
Ekip Link
...
Continued on the next page