Removing The Pci Riser-Card Assembly - Lenovo Converged HX Series Installation And Service Manual

Bezel (Intel X520)
Figure 55. LAN Mezz adapter installation (Intel X520)
Bezel (RJ 45)
Figure 56. LAN Mezz adapter installation (RJ 45)
Step 5. Reinstall the bezel by tighten the 2 screws.
Step 6. Reinstall compute node (see "Installing a compute node in a chassis" on page 82).
1. Install the server into the rack enclosure and push the server into the rack until it clicks into place.
2. Reconnect any cables that you removed.
3. Turn on the peripheral devices and the server.
Note: If the server is configured for RAID operation through an optional RAID adapter, you might have to
reconfigure your disk arrays after you install an adapter.

Removing the PCI riser-card assembly

Use this information to remove the PCI riser-card assembly.
Read the safety information in "Safety" on page iii and "Installation guidelines" on page 79.
If you are replacing a server component or installing an optional device in the server, you need to take out the
node out from the rack enclosure, turn off the server and peripheral devices, and disconnect all external
cables.
To remove the PCI riser-card assembly, complete the following steps.
122
Lenovo Converged HX3710, HX2710-E, HX3710-F Type 8689, Lenovo Converged HX Enclosure Type 5495 Installation and Service Guide
OCP adapter
(Intel X520)
OCP connector
OCP adapter
(RJ-45)
OCP connector