Table of Contents
Advertisement
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the blade server
v Take additional care when you handle devices during cold weather. Heating
Returning a device or component
Use this information for instructions to return a device or component to service
and support.
If you are instructed to return a device or component, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
Removing the blade server from the BladeCenter unit
Use these instructions to remove the blade server from the BladeCenter unit.
The following illustration shows how to remove a single-width type of blade
server or blade filler from a BladeCenter unit. The appearance of your BladeCenter
unit might be different; see the documentation for your BladeCenter unit for
additional information.
metal part of the BladeCenter unit or any unpainted metal surface on any other
grounded rack component in the rack in which you are installing the device for
at least 2 seconds. This drains static electricity from the package and from your
body.
without setting down the device. If it is necessary to set down the device, put it
back into its static-protective package. Do not place the device on the blade
server cover or on a metal surface.
reduces indoor humidity and increases static electricity.
Chapter 5. Removing and replacing blade server components
49
Advertisement
Table of Contents
