Self-Tests Tab; Logs Tab - Welch Allyn Connex Vital Signs Monitor 6000 Series Service Manual

26 Service menu
Send device information to PartnerConnect
The device sends technical information, such as log files, to PartnerConnect periodically.
You can also manually send this information at any time by following this procedure.
1. Go to the Service screens as described in "Access the Service screens."
2. Touch the General tab.
3. Touch Sync with server.

Self-tests tab

Calibrate the touchscreen
This tab calibrates the touchscreen, if needed.
1. Go to the Service screens as described in "Access the Service screens."
2. Touch the Self-tests tab.
3. Touch Start.
a. Touch the location indicated by the device. The device checks the current
b. If the locations do not match, a calibration failure dialog appears. Touch

Logs tab

View an error or event log
1. Go to the Service screens as described in "Access the Service screens."
2. Touch the Logs tab.
3. View a log report.
•
•
Save error and event logs to a USB flash drive
This feature is available in software versions 1.71.03 and later.
You can save a copy of the error and event logs to a USB flash drive.
Note
1. Connect a flash drive to the USB port.
2. Go to the Service screens as described in "Access the Service screens."
3. Touch the Logs tab.
4. Touch Save to USB.
A confirmation dialog appears.
calibration. If the location coordinates and touched location match, a Calibration
Confirmation dialog appears. Touch OK to finish.
Calibrate, and then touch the screen as indicated. When calibration is complete,
a Calibration Confirmation dialog appears. Touch OK to finish.
To view an error log, select Error.
To view an event log, select Event.
Not all flash drives are supported.
®
Welch Allyn Connex Vital Signs Monitor 6000 Series™