Welch Allyn Connex Vital Signs Monitor 6000 Series Service Manual page 31

Service manual
2. Go to the Service screens as described in "Access the Service screens."
3. Touch the General tab.
4. Select Configure from USB.
A confirmation dialog appears.
5. Select Device configuration and/or Custom data XML.
A confirmation dialog appears to confirm overwriting the existing configuration.
6. Select OK to proceed, or Cancel to quit.
The configuration from the USB flash drive overwrites the configuration on the
device, and the device reboots.
Note
Note
Note
Delete custom data
To delete custom data, you must restore the monitor to factory defaults. Restoring the
monitor to factory defaults also deletes all configuration settings.
To restore the custom configuration settings, save the configuration file to a drive and
reload the file after restoring factory defaults.
To determine if custom data is loaded on the device, complete these steps:
1. Go to the Service screens as described in "Access the Service screens."
2. Touch the Device tab.
A Custom file line displays the configuration name and the CRC in the Firmware
version column.
Enter an asset tag
You can enter an alpha-numeric identifier in the data field to serve as an asset tag for
device identification.
1. Go to the Service screens as described in "Access the Service screens."
2. Touch the General tab.
3. Touch
4. Touch OK.
Note
If device configuration data is not present on the USB drive, that option will
be disabled.
If custom modifiers are not present on the USB drive, that option will be
disabled.
If the configuration file is incompatible, an Unable to read configuration
from USB message appears. This might be the case if the configuration
file was cloned from a device with different software version.
and enter up to 20 characters.
If the device language changes, the asset tag remains
unchanged.
Service menu 25