Welch Allyn Connex Vital Signs Monitor 6000 Series Service Manual page 100

94 Section A
2. Slide the NIBP module out of the case.
Reassembly notes
• Install the NIBP module (the module closest to the display) before installing the
SpO2 and CO2 modules.
• Insert the NIBP module into the housing with the serial number label facing up.
• Connect the USB cable to the NIBP module.
• If originally installed, install the blanking panel by sliding it into the housing.
Remove the bottom housing
Bottom housing for the standard chassis
No.
10
25
Item
Screw, plastite #4-20 X 0.500 Torx-pan head
Bottom housing metal chassis
®
Welch Allyn Connex Vital Signs Monitor 6000 Series™
No. Item
27 Bottom housing
28 Battery connector board