Welch Allyn Connex Vital Signs Monitor 6000 Series Service Manual page 146

140 Section B
4. Remove the ground stud AC power harness assembly.
Reassembly notes
When replacing the rear case or AC power harness, route the wiring as follows:
• Connect blue to neutral (N), green to ground (GND), and brown to line (L).
Note
• Ensure that the grommet on the AC power harness is in the slot in the power supply
cover.
• Place ferrite on the AC power harness assembly into the molded feature on the back
housing and then check the following details:
○
The power supply harness to IEC connector is rated for a single
connection. Replace the power supply harness if it has been disconnected
from the IEC connector.
Ensure that the edge of the ferrite is inside the edge of the molded feature.
®
Welch Allyn Connex Vital Signs Monitor 6000 Series™