170 Section B
No.
Item
49c
LCD with touchscreen
51
Foam pad, top and bottom
Remove the light bar
Before you begin, remove the following as described in this manual:
•
Battery
•
Rear housing
•
CO2 module or blank faceplate
•
EarlySense module
•
SpO2 module or blank faceplate
•
NIBP module
•
Bottom housing
•
Top housing
1. Remove the three screws (10) that secure the horizontal strut (located on the right
side when facing the device from the back) to the front housing.
2. Remove the strut.
3. Remove the tape that secures the light-bar harness to the LCD frame.
®
Welch Allyn Connex
Vital Signs Monitor 6000 Series™
No.
Item
95
LCD frame ground wire
96
Lock washer