Microhard Systems BulletPlus Operating Manual page 97

4.0 Configuration
This will display the current BulletPlus WAN (Cellular) IP Address.
Enter the IP Address of the Remote Gateway that you wish to establish a
connection with.
Some servers require that you know the Server ID as well as the IP
address. Enter the Server ID of the remote router here.
In order to communicate with the devices on the other side of the tunnel,
the BulletPlus must know which data to pass through the tunnel, to do this
enter the Remote Subnet network IP address here.
Enter the Remote Subnet Mask
Enter the Idle time (in seconds) to wait before giving up the PPP
connection. The default is 0, which means the time is infinite. (0—65535)
Enter the Username
The preshared key is required to connect to the L2TP Server.
IPSec Setup - See previous sections for additional info.
© Microhard Systems Inc.
Local Interface IP Address
Values (IP Address)
Current IP
Remote Gateway IP Address
Values (IP Address)
none
Remote Server ID
Values
none
Remote Subnet IP
Values (IP Address)
none
Remote Subnet Mask
Values (IP Address)
none
Idle time before hanging up
Values (seconds)
0
Username
Values (chars)
0
Preshared Key
Values (chars)
0
97