Date/Time - Microhard Systems BulletPlus Operating Manual

4.0 Configuration
The BulletPlus can report system level events to a third party Syslog
server, which can be used to monitor events reported by the BulletPlus.
Enter the UDP listening port of the Syslog Server. The default port number
is generally 514, but could vary from Server to Server.
Time Settings
The BulletPlus can be set to use a local time source, thus keeping time on its own, or it can be configured
to synchronize the date and time via a NTP Server. The options and menus available will change
depending on the current setting of the Date and Time Setting Mode, as seen below.
Network Time Protocol (NTP)
can be used to synchronize the
time and date or computer
systems with a centralized,
referenced server. This can
help ensure all systems on a
network have the same time
and date.
Select the Date and Time Setting Mode required. If set for 'Use
Local Time' the unit will keep its own time and not attempt to
synchronize with a network server. If 'Synchronize Date And
Time Over Network' is selected, a NTP server can be defined.
The calendar date may be entered in this field. Note that the
entered value is lost should the BulletPlus lose power for some
reason.
© Microhard Systems Inc.
Image 4-1-3: System Settings > Time Settings
System Syslog Server IP
IP Address
0.0.0.0
System Syslog Server Port
UDP Port
514
Date and Time Setting Mode
Values (selection)
Use Local Time Source
Synchronize Date And Time
Over Network
(yyyy-mm-dd)
Values
2015.04.01 (varies)
Date
26