Microhard Systems BulletPlus Operating Manual page 123

4.0 Configuration
The Message field allows customization of up to 4 different GPS messages
to be sent to the specified host.
The trigger condition defines the conditions that must be met before a GPS
update is reported. If OR is chosen, the Repeater Timer OR the Distance
trigger conditions must be met before an update is sent. The AND
condition, requires that both the Repeat timer AND the Distance trigger
conditions be met before an update is sent.
The distance parameter allows the GPS data to only be sent when a
specified distance has been traveled since the last report.
This is the IP Address and port of the remote host in which the UDP
packets are to be sent.
If an Email report is chosen, the subject line of the Email can be defined
here.
If an Email report is to be sent, the outgoing mail server must be defined,
and the port number.
Some outgoing mail servers required username and password to prevent
an account being used for spam. Enter the login credentials here.
Some outgoing mail servers require a username and password to prevent
an account being used for spam. Enter the login credentials here.
© Microhard Systems Inc.
None - Message is not used, no data will be sent
ALL - Sends all of the below
GGA - GPS Fix Data
GSA - Overall Satellite Data
GSV - Detailed Satellite Data
RMC - Recommended Min Data for GPS
VTG - Vector Track & Ground Speed
GPSGate - For use with GPSGate Tracking Software
Message 1-4
Values (selection)
None
ALL NMEA
GGA
GSA
GSV
RMC
VTG
Latitude/Longitude
GPSGate UDP Protocol
Trigger Set
Values (selection)
Only Timer
Timer AND Distance
Timer OR Distance
Distance Set
Values (meters)
1000
UDP Remote IP / Port
Values
(Address/Port)
0.0.0.0 / 20175
Mail Subject
Values (characters)
1000
Mail Server
Values
(Address:port)
smtp.gmail.com:465
Username / Password
Values (characters)
Username / password
Mail Recipient
Values (characters)
host@email.com
123