Microhard Systems BulletPlus Operating Manual page 74

4.0 Configuration
This setting determines the rate at which the data is to be wirelessly transferred.
The default is 'Auto' and, in this configuration, the unit will transfer data at the highest possible rate in
consideration of the receive signal strength (RSSI).
Setting a specific value of transmission rate has the benefit of 'predictability' of that rate, but if the RSSI
drops below the required minimum level to support that rate, communications will fail.
Disabling the SSID broadcast helps secure the wireless network.
Enabling the broadcast of the SSID (Network Name) will permit others
to 'see' the wireless network and perhaps attempt to 'join' it.
When AP Isolation is enabled wireless devices connected to this SSID
will not be able to communicate with each other. In other words if the
BulletPlus is being used as a Hot Spot for many wireless clients, AP
Isolation would provide security for those clients by not allowing
access to any other wireless device.
WiFi Multimedia (WMM) is a feature that enhances the quality of
service on a network by prioritizing data packets according to data
type. (Video, Voice, Best Effort, Background).
© Microhard Systems Inc.
802.11 b/g
Auto
1 Mbps (802.11b,g)
2 Mbps (802.11b,g)
5.5 Mbps (802.11b,g)
11 Mbps (802.11b,g)
6 Mbps (802.11g)
9 Mbps (802.11g)
12 Mbps (802.11g)
18 Mbps (802.11g)
24 Mbps (802.11g)
36 Mbps (802.11g)
48 Mbps (802.11g)
54 Mbps (802.11g)
TX bitrate
802.11n (HT20/HT40)
Auto
mcs-0 (7.2/15) Mbps
mcs-1 (14.4/30.0) Mbps
mcs-2 (21.7/45.0) Mbps
mcs-3 (28.9/60.0) Mbps
mcs-4 (43.3/90.0) Mbps
mcs-5 (57.8/120.0) Mbps
mcs-6 (65.0/135.0) Mbps
mcs-7 (72.2/150.0) Mbps
ESSID Broadcast
Values (selection)
On / Off
AP Isolation
Values (selection)
On / Off
WMM
Values (selection)
On / Off
74