Microhard Systems BulletPlus Operating Manual page 60

4.0 Configuration
A User Name may be required for authentication to a remote peer.
Although usually not required for dynamically assigned IP addresses
from the wireless carrier. Varies by carrier.
Enter the password for the user name above. May not be required by
some carriers, or APN's
Network+
In some cases the Static IP address must be entered in this field if
assigned by a wireless carrier. In most cases the IP will be read from
the SIM card and this field should be left at the default value.
If enabled the Bullet with use the DNS server as specified
automatically by the service provider.
Use this interface as the default route for all outbound traffic unless
specified in the Network > Routes table.
When enabled DNS-Passthrough will pass on the WAN assigned DNS
information to the end device.
SIM Card-2 Settings
Settings for SIM Card-2 are identical to that of SIM Card-1, refer to the previous section for information on
how to configure SIM Card-2.
© Microhard Systems Inc.
User Name
Values (characters)
Carrier/peer dependant
Password
Values (characters)
Carrier/peer dependant
IP Address
Values (IP Address)
(none)
Use Remote DNS
Values (selection)
Enable / Disable
Default Route
Values (Selection)
Yes / No
DNS-Passthrough
Values (Selection)
Enable / Disable
60