Microhard Systems BulletPlus Operating Manual page 64

4.0 Configuration
Enable or disable the RSSI alerts.
Set the threshold for RSSI alerts. When the signal strength drops
below this threshold, an SMS alert will be sent to the number(s)
specified.
Enable or disable SMS Alerts for Roaming Status.
The BulletPlus can send alerts based on the roaming status. Data
rates during roaming can be expensive and it is important to know
when a device has started roaming.
Enable or disable SMS Alerts for the Ethernet Link status of the LAN
RJ45 port.
The status of the Ethernet Link of the LAN (RJ45) can be used to send
SMS Alerts. The link status may indicate an issue with the connected
device.
SMS Alerts can be sent based on the state changes of the Digital I/O
lines.
© Microhard Systems Inc.
RSSI Check
Values (Selection)
Disable RSSI check
Enable RSSI check
Low Threshold (dBm)
Values (dBm)
-99
Carrier Network
Values (Selection)
Disable Roaming Check
Enable Roaming Check
Home / Roaming Status
Values (Selection)
In Roaming
Changed or In Roaming
Changed to Roaming
Ethernet
Values (Selection)
Disable Ethernet check
Enable Ethernet check
Ethernet Link Status
Values (Selection)
Changed
In no-link
Changed or in no-link
Changed to no-link
I/O Status
Values (Selection)
Disable IO Check
Enable: INPUT Changed
Enable: Output Changed
Enable: INPUT or OUTPUT
Changed.
64