Microhard Systems BulletPlus Operating Manual page 55

4.0 Configuration
The Ping mode allows for the selected hosts to be pinged either
Sequentially or Simultaneously. This option is only displayed when the
failover mode is set to ICMP.
This is the amount of time the Health Monitor will wait for a response
from the ICMP Host (when type is configured as ICMP).
This is the number of attempts the BulletPlus will attempt to reach the
IMCP host before going into failover and switching WAN interfaces.
The BulletPlus will continue to monitor the failed interface, even after
failover has occurred. This defines the number of successful attempts
required before recovering the failed interface.
Once the preferred connection is again deemed available, it can be
specified to wait a configurable amount of time before restoring the
connection.
© Microhard Systems Inc.
Values (seconds)
3
ICMP Timeout
Values (seconds)
3
Attempts Before Failover
Values (selection)
1, 3, 5, 10, 15, 20
Attempts Before Recovery
Values (selection)
1, 2, 5, 10, 15, 20
Recovery Immediate Mode / Wait
Values (selection)
Disable / Enable
Ping Mode
55