Microhard Systems BulletPlus Operating Manual page 126

4.0 Configuration
Enable GpsGate Tracker Mode or TCP modes. In TCP Mode the
BulletPlus will establish a connection with the GpsGate Server directly
without the SMS setup process. If the TCP connection is not available, the
BulletPlus will continue to try to connect every few seconds.
Enter the IP Address of the server running the GpsGate application.
Enter the TCP Port of the server running the GpsGate application.
Define the interval at which the BulletPlus will send data to the GpsGate
Server.
Set the motion threshold in which the BulletPlus will be triggered to send
location data.
When enabled, the BulletPlus will send the current status of the Digital I/O
inputs and/or outputs to the GpsGate Server.
Specify what happens when the GPS data is invalid, either use the last
valid position or do not use the last valid position.
© Microhard Systems Inc.
Values (selection)
Disable
Enable Tracker Mode
Enable TCP Send Mode
Server Address / IP
Values (IP Address)
0.0.0.0
Values (Port)
30175
Server Interval
Values (seconds)
60
Motion Distance
Values (meters)
100
Send IO Status
Values (selection)
Disable
Send Input Status
Send Output Status
Send Input&Output Status
When GPS Invalid, Sending Data
Values (selection)
Not Use Last Valid Position
Use Last Valid Position
Mode Set
Server Port
126