At Command Syntax - Microhard Systems BulletPlus Operating Manual

5.0 AT Command Line Interface

5.2 AT Command Syntax

The follow syntax is used when issuing AT Commands on the BulletPlus
A screen capture of the above commands entered into a unit is shown below:
Once AT commands are entered, they must be saved into the file system to enable the changes.
© Microhard Systems Inc.
- All commands start with the AT characters and end with the <Enter> key
- Microhard Specific Commands start with +M
- Help will list top level commands (ATL will list ALL available AT Commands)
- To query syntax of a command: AT+<command_name>=?
- Syntax for commands that are used only to query a setting:
AT<command_name>
- Syntax for commands that can be used to query and set values:
AT<command_name>=parameter1,parameter2,... (Sets Values)
AT<command_name>? (Queries the setting)
Query Syntax:
AT+MSMNAME=? <Enter>
+MSMNAME: Command Syntax:AT+MLEIP=<modem_name>
OK
Setting a value:
AT+MSMNAME=BulletPlus-Test <Enter>
OK
Query a setting:
AT+MSMNAME? <Enter>
Host name:BulletPlus-Test
OK
Image 5-5: Telnet AT Command Syntax
AT&W Saves changes.
ATO or ATA Exits the AT Command Line Interface, if used before AT&W,
changes are discarded.
162