Microhard Systems BulletPlus Operating Manual page 176

5.0 AT Command Line Interface
Description
Get/Set the LAN DHCP Server when WASN port set as Independent LAN.
Command Syntax (Effect: AT&W)
AT+MNWANLANDHCP[=<Mode>[,<Start IP>,<Limit>,<Lease Time>[,<Alt.Gateway>,<Pre.DN
S>,<Alt.DNS>]]]
Usage:
AT+MNWANLANDHCP
AT+MNWANLANDHCP=<Mode> Where <Mode>=0
AT+MNWANLANDHCP=<Mode>,<Start IP>,<Limit>,<Lease Time>[,<Alt.Gateway>,<Pre.DNS>
,<Alt.DNS>] Where <Mode>=1
Parameters:
Mode: 0 - Disable DHCP Server
Start IP: The starting address DHCP assignable IP Addresses
Limit: The maximum number of IP addresses. min=0 max=16777214
Lease Time: The DHCP lease time in minutes. 2~2147483647 minutes. 0 means 'infinity'
Alt. Gateway: Alternate Gateway for DHCP assigned devices if the default gateway is not to be used
Pre. DNS: Preferred DNS server address to be assigned to DHCP devices
Alt. DNS: Alternate DNS server address to be assigned to DHCP devices
Example
Input:
AT+MNWANLANDHCP=0<enter>
Response:
OK
© Microhard Systems Inc.
1 - Enable DHCP Server
AT+MNWANLANDHCP
176