Services; Ftp; Telnet; Http/Https - Microhard Systems BulletPlus Operating Manual

4.0 Configuration
4.1.3 System > Services
Certain services in the BulletPlus can be disabled or enabled for either security considerations or resource/
power considerations. The Enable/Disable options are applied after a reboot and will take affect after each
start up. The Start/Restart/Stop functions only apply to the current session and will not be retained after a
power cycle.
The FTP service can be enabled/disabled using the Services Status
Menu. The FTP service is used for firmware recovery operations.
Using the Telnet Service Enable/Disable function, you can disable the
Telnet service from running on the modem. The port used by the
Telnet service can also be modified. The default is 23.
Using the SSH Service Enable/Disable function, you can disable the
SSH service (Port 22) from running on the modem. The port used by
the SSH service can also be modified. The default is 22.
The default web server port for the web based configuration tools used
in the modem is port 80 (http) and port 443 (HTTPS).
Change as required, but keep in mind that if a non standard port is
used, it must be specified in a internet browser to access the unit.
(example: http://192.168.168.1:8080).
Reserved for internal use.
© Microhard Systems Inc.
Image 4-1-5: System > Services

FTP

Values (port)
Enable / Disable

Telnet

Values (port)
23
SSH
Values (port)
22
Web UI
(selection)
Values

HTTP/HTTPS

HTTP
HTTPS
Microhard Sh
28