Lan Dhcp - Microhard Systems BulletPlus Operating Manual

4.0 Configuration

LAN DHCP

A BulletPlus may be configured to provide dynamic host control protocol (DHCP) service to all attached
(either wired or wireless (WiFi)-connected) devices. By default the DHCP service is enabled, so devices
that are connected to the physical Ethernet LAN ports, as well as any devices that are connected by WiFi
will be assigned an IP by the BulletPlus. The LAN DHCP service is available for each interface, and is
located in the add/edit interface menus.
The option is used to enable or disable the DHCP service for devices
connected to the LAN Port(s).
Prior to enabling this service,
verify that there are no other
devices - either wired (e.g.
LAN) or wireless with an
active DHCP SERVER
service. (The Server issues
IP address information at the
Select the starting address DHCP assignable IP Addresses. The first
request of a DHCP Client,
octets of the subnet will be pre-set based on the LAN IP configuration,
which receives the
information.)
and can not be changed.
Set the maximum number of IP addresses that can be assigned by the
BulletPlus.
The DHCP lease time is the amount of time before a new request for a
network address must be made to the DHCP Server.
Specify an alternate gateway for DHCP assigned devices if the default
gateway is not to be used.
© Microhard Systems Inc.
Image 4-2-4: Network > DHCP Server
DHCP Server
Values (selection)
Enable / Disable
Start
Values (IP Address)
192.168.168.100
Limit
Values (integer)
150
Lease Time
Values (minutes)
720
Alternate Gateway
Values (IP Address)
(IP Address)
37