Microhard Systems BulletPlus Operating Manual page 154

4.0 Configuration
The BulletPlus can report information about the different interfaces it has.
By default the BulletPlus is set to send information about the Carrier, such
as usage and RSSI. Statistical and usage data on the Radio (WiFi),
Ethernet and Serial interfaces can also be reported.
The more that is reported, the more data that is sent to the NMS system,
be aware of data plan constraints and related costs.
Webclient Setting
The Web Service can be enabled or disabled. This service is used to
remotely control the BulletPlus. It can be used to schedule reboots,
firmware upgrade and backup tasks, etc.
Select between HTTPS (secure), or HTTP server type.
This is the port where the service is installed and listening. This port should
be open on any installed firewalls.
This is the username and password used to authenticate the unit.
The Interval defines how often the BulletPlus checks with the NMS System
to determine if there are any tasks to be completed. Carrier data will be
consumed every time the device probes the NMS system.
© Microhard Systems Inc.
Information Selection
Values
(check boxes)
Ethernet
Carrier
Radio
COM
DI / DO
Status
Values (chars)
Disable/Enable
Server Type
Values (chars)
HTTPS/ HTTP
Server Port
Values (Port#)
9998
Username / Password
Values (seconds)
admin/admin
Interval
Values (min)
60
154