Microhard Systems BulletPlus Operating Manual page 100

4.0 Configuration
If enabled (Auto) the server will push its DNS server information to the
client. Manual allows the DNS information to be manually entered.
When select yes, the clients will not see each other. Select no, it will allow
different clients to be able to "see" each other. By default, clients will only
see the server.
The keep alive directive causes ping-like messages to be sent back and
forth over the link so that each side knows when the other side has gone
down. Default 10 seconds.
Default 120 seconds. Ping every 10 seconds, assume that remote peer is
down if no ping received during a 120 second time period. (must be at least
twice the interval specified above)
Select a cryptographic cipher. Must be the same on Server and Client.
Enable/Disable LZO compression on the VPN link. Lempel–Ziv–
Oberhumer (LZO) is a lossless data compression algorithm.
OpenVPN support multiple subnet behind server/client. So that the vpn
connection can reach the subnet behind. Each subnet must be specified to
the data can be routed correctly.
© Microhard Systems Inc.
Push DNS to Client
Values (selection)
NO / Auto / Manual
Values (selection)
No / Yes
Keep Alive Ping Interval
Values (seconds)
10
Keep Alive Ping Period
Values (seconds)
120
Values (selection)
DES-CBC
RC2-CBC
DES-EDE-CBC
DES-EDE3-CBC
DESX-CBC
BF-CBC
RC2-40-CBC
CAST5-CBC
RC2-64-CBC
AES-128-CBC
AES-192-CBC
AES-256-CBC
SEED-CBC
Use LZO Compression
Values (selection)
Enable / Disable
OpenVPN Server Network Settings
Values (selection)
(no default)
Client Isolation
Cipher
100