Ldap Parameters - AudioCodes Mediant 3000 User Manual

Parameter
Web: Cost Group Table
EMS: Cost Group
Provisioning > Cost Group
[CostGroupTable]
Web: Cost Group > Time
Band Table
EMS: Time Band
Provisioning > Time Band
[CostGroupTimebands]

53.13 LDAP Parameters

The Lightweight Directory Access Protocol (LDAP) parameters are described in the table
below. For more information on routing based on LDAP, see 'Routing Based on LDAP
Active Directory Queries' on page 205.
Parameter
Web: LDAP Service
[LDAPServiceEnable]
Web: LDAP Server IP
EMS: Server Ip
[LDAPServerIP]
Web: LDAP Server Port
EMS: Server Port
[LDAPServerPort]
User's Manual
[ RoutingRuleGroups ]
FORMAT RoutingRuleGroups_Index =
RoutingRuleGroups_LCREnable,
RoutingRuleGroups_LCRAverageCallLength,
RoutingRuleGroups_LCRDefaultCost;
[ \RoutingRuleGroups ]
Note: For a detailed description of this table, see 'Enabling LCR and
Configuring Default LCR' on page 217.
This table parameter configures the Cost Groups for LCR, where
each Cost Group is configured with a name, fixed call connection
charge, and a call rate (charge per minute).
[ CostGroupTable ]
FORMAT CostGroupTable_Index =
CostGroupTable_CostGroupName,
CostGroupTable_DefaultConnectionCost,
CostGroupTable_DefaultMinuteCost;
[ \CostGroupTable ]
For example: CostGroupTable 2 = "Local Calls", 2, 1;
Note: For a detailed description of this table, see 'Configuring Cost
Groups' on page 219.
This table parameter configures time bands and associates them
with Cost Groups.
[CostGroupTimebands]
FORMAT CostGroupTimebands_TimebandIndex =
CostGroupTimebands_StartTime, CostGroupTimebands_EndTime,
CostGroupTimebands_ConnectionCost,
CostGroupTimebands_MinuteCost;
[\CostGroupTimebands]
Note: For a detailed description of this table, see 'Configuring Time
Bands for Cost Groups' on page 220.
LDAP Parameters
Enables the LDAP feature.

[0] Disable (default)

[1] Enable
Note: For this parameter to take effect, a device reset is required.
Defines the LDAP server's address as an IP address (in dotted-
decimal notation, e.g., 192.10.1.255).
The default is 0.0.0.0.
Defines the LDAP server's port number.
The valid value range is 0 to 65535. The default port number is 389.
832
Description
Description
Document #: LTRT-89729
Mediant 3000