Routing; Configuring General Routing Parameters; Configuring Outbound Ip Routing Table - AudioCodes Mediant 3000 User Manual

User's Manual
24

Routing

This section describes the configuration of call routing rules.
24.1

Configuring General Routing Parameters

The Routing General Parameters page allows you to configure general routing parameters.
For a description of these parameters, see 'Configuration Parameters Reference' on page
643.

To configure general routing parameters:
1. Open the Routing General Parameters page (Configuration tab > VoIP menu > GW
and IP to IP submenu > Routing submenu > General Parameters).
2. Configure the parameters as required.
3. Click Submit to apply your changes.
24.2

Configuring Outbound IP Routing Table

The Outbound IP Routing Table page allows you to configure up to 180 Tel-to-IP or
outbound IP call routing rules. The device uses these rules to route calls from the Tel or IP
to a user-defined IP destination.
Configuration of Tel-to-IP routing rules includes two areas:

Matching Charcateristics: Defines the characteristics of the incoming Tel call (e.g.,
Trunk Group on which the call is received).

Destination: Defines the action that is done if the incoming call matches the
characteristics of the rule (i.e., routes the call to the specified IP destination).
The device searches the table from top to bottom for the first rule that matches the
characteristics of the incoming call. If it finds a matching rule, it sends the call to the IP
destination configured for that rule. If it doesn't find a matching rule, it rejects the call.
The matching characteristics of the incoming call can be one or more of the following:
Version 6.6
Figure 24-1: Routing General Parameters Page
355
24. Routing
Mediant 3000