AudioCodes Mediant 3000 User Manual page 636

♦
♦
♦
Alternatively, if you want to route the test call using the Outbound IP Routing table for
the Gateway / IP-to-IP application, configure the following:
•
Test Call table configuration:
♦
♦
♦
♦
•
Outbound IP Routing table configuration:
♦
♦
♦

Batch Test Call Scenario: This example describes the configuration of a batch test
call setup for scheduled and continuous call testing of multiple endpoints. The test call
is done between two AudioCodes devices - Device A and Device B - with simulated
test endpoints. This eliminates the need for phone users, who would otherwise need
to answer and end calls many times for batch testing. The calls are initiated from
Device A, where Device B serves as the remote answering endpoint.
•
Test Call table configuration at Device A:
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
♦
•
Test Call table configuration at Device B:
♦
♦
♦
User's Manual
Destination Address: "10.30.40.01"
Call Party: Caller
Test Mode: Once (default)
Endpoint URI: 101@10.0.0.1
Route By: GW Tel2IP
Called URI: 201@10.30.40.1
Call Party: Caller
Dest. Phone Prefix: 201 (i.e., the Called URI user-part)
Source Phone Prefix: 101 (i.e., the Endpoint URI user-part)
Dest. IP Address: 10.30.40.1
Figure 51-9: Batch Test Call Example
Endpoint URI: "101"
Called URI: "201"
Route By: Dest Address
Destination Address: "10.13.4.12"
Call Party: Caller
Maximum Channels for Session: "3" (this setting configures three endpoints -
"101", "102" and "103)
Call Duration: "5" (seconds)
Calls per Sec: "1"
Test Mode: Continuous
Test Duration: "3" (minutes)
Schedule Interval: "180" (minutes)
Endpoint URI: "201"
Call Party: Caller
Maximum Channels for Session: "3" (this setting configures three endpoints -
"201", "202" and "203)
636
Mediant 3000
Document #: LTRT-89729