AudioCodes Mediant 3000 User Manual page 827

User's Manual
Parameter
Web/EMS: Swap Redirect
and Called Numbers
[SwapRedirectNumber]
[UseReferredByForCalling
Number]
[SwapTel2IPCalled&Callin
gNumbers]
Web/EMS: Add Prefix to
Redirect Number
[Prefix2RedirectNumber]
Web: Add Number Plan and
Type to RPI Header
EMS: Add Ton 2 RPI
[AddTON2RPI]
Web/EMS: Source
Manipulation Mode
[SourceManipulationMode
]
Calling Name Manipulations IP-to-Tel Table
[CallingNameMapIp2Tel]
Version 6.6

[0] No = (Default) Don't change numbers.

[1] Yes = Incoming ISDN call that includes a redirect number
(sometimes referred to as 'original called number') uses the redirect
number instead of the called number.
Determines whether the device uses the number from the URI in the
SIP Referred-By header as the calling number in the outgoing Q.931
Setup message, when SIP REFER messages are received.

[0] = (Default) No

[1] = Yes
Notes:

This parameter is applicable to all ISDN (TBCT, RLT, ECT) and CAS
blind call transfers (except for in-band) and when the device receives
SIP REFER messages with a Referred-By header.

This manipulation is done before regular IP-to-Tel source number
manipulation.
Determines whether the device swaps the calling and called numbers
received from the Tel side (for Tel-to-IP calls). The SIP INVITE
message contains the swapped numbers.

[0] = (Default) Disabled

[1] = Swap calling and called numbers
Note: This parameter can also be configured in a Tel Profile.
Defines a string prefix that is added to the Redirect number received
from the Tel side. This prefix is added to the Redirect Number in the SIP
Diversion header.
The valid range is an 8-character string. The default is an empty string.
Determines whether the TON/PLAN parameters are included in the
Remote-Party-ID (RPID) header.

[0] No

[1] Yes (default)
If the Remote-Party-ID header is enabled (EnableRPIHeader = 1) and
AddTON2RPI = 1, it's possible to configure the calling and called
number type and number plan using the Number Manipulation tables for
Tel-to-IP calls.
Determines the SIP headers containing the source number after
manipulation:

[0] = (Default) The SIP From and P-Asserted-Identity headers
contain the source number after manipulation.

[1] = Only SIP From header contains the source number after
manipulation, while the P-Asserted-Identity header contains the
source number before manipulation.
Configures rules for manipulating the calling name (caller ID) in the
received SIP message for IP-to-Tel calls. This can include modifying or
removing the calling name. The format of this table ini file parameter is
as follows:
[ CallingNameMapIp2Tel ]
FORMAT CallingNameMapIp2Tel_Index =
CallingNameMapIp2Tel_DestinationPrefix,
CallingNameMapIp2Tel_SourcePrefix,
827
53. Configuration Parameters Reference
Description
Mediant 3000