Dialing Plans For Digit Collection - AudioCodes Mediant 3000 User Manual

User's Manual
"[...]" on a new line.

Each line under the Dial Plan index defines a rule.

Empty lines are ignored.

Lines beginning with a semicolon ";" are ignored. The semicolon can be used for
comments.

To create a Dial Plan file:
1. Create a new file using a text-based editor (such as Notepad) and configure your Dial
Plans, as required.
2. Save the file with the ini file extension name (e.g., mydialplanfile.ini).
3. Convert the ini file to a dat binary file, using AudioCodes DConvert utility. For more
information, refer to DConvert Utility User's Guide.
4. Install the converted file on the device, as described in 'Loading Auxiliary Files' on
page 525.
5. Select the Dial Plan index that you want to use. This depends on the feature and is
described in the respective section.

41.1.4.2 Dialing Plans for Digit Collection

The device enables you to configure multiple dialing plans in an external Dial Plan file,
which can be installed on the device. If a Dial Plan file is implemented, the device first
attempts to locate a matching digit pattern in a specified Dial Plan index listed in the file
and if not found, attempts to locate a matching digit pattern in the Digit Map. The Digit Map
is configured by the 'Digit Mapping Rules' parameter, located in the DTMF & Dialing page
(Configuration tab > VoIP menu > GW and IP to IP > DTMF and Supplementary >
DTMF & Dialing).
The Dial Plan is used for the following:

ISDN Overlap Dialing (Tel-to-IP calls): The file allows the device to know when digit
collection ends, after which it starts sending all the collected (or dialed) digits in the
outgoing INVITE message. This also provides enhanced digit mapping.

CAS E1 MF-CR2 (Tel-to-IP calls): Useful for E1 MF-CR2 variants that do not support
I-15 terminating digits (e.g., in Brazil and Mexico). The Dial Plan file allows the device
to detect end-of-dialing in such cases. The CasTrunkDialPlanName_x ini file
parameter determines which dial plan (in the Dial Plan file) to use for a specific trunk.
Notes:
The Dial Plan file can contain up to eight Dial Plans (Dial Plan indices), with a total of up to
8,000 dialing rules (lines) of distinct prefixes (e.g. area codes, international telephone
number patterns) for the PSTN to which the device is connected.
Version 6.6
•
To use the Dial Plan file, you must also use a special CAS .dat file that
supports this feature. For more information, contact your AudioCodes
sales representative.
•
For E1 CAS MFC-R2 variants, which don't support terminating digit for
the called party number, usually I-15, the Dial Plan file and the
DigitMapping parameter are ignored. Instead, you can define a Dial Plan
template per trunk using the parameter CasTrunkDialPlanName_x.
531
41. Software Upgrade
Mediant 3000