To configure logging filtering rules:
1.
Open the Logging Filters Table page (Configuration tab > System menu > Logging
> Logging Filters Table).
2.
Click the Add button; the Add Record dialog box appears:
Figure 49-2: Logging Filters Table - Add Record Dialog Box
3.
Configure the logging filter, as required. See the table below for a description of the
parameters.
4.
Click Submit to save your changes.
Notes:
Parameter
Filter Type
CLI: filter-type
[LoggingFilters_Ty
pe]
User's Manual
•
To configure the Syslog debug level, use the 'Debug Level' parameter
(see 'Configuring Syslog' on page 616).
•
The Logging Filters table can also be configured using the table ini file
parameter, LoggingFilters.
Logging Filters Table Parameters Description
Defines the filter criteria.
[1] Any (default)
[2] Trunk ID = Filters according to a specified Trunk ID (applicable only
to the Gateway application).
[3] Trunk Group ID = Filters according to a specified Trunk Group ID
(Applicable only to the Gateway/IP-to-IP application).
[4] Trunk & B-channel = Filters according to a specified Trunk and B-
channel (applicable only to the Gateway/IP-to-IP application).
[6] Tel-to-IP = Filters according to a specified Tel-to-IP routing rule listed
in the Outbound IP Routing table (applicable only to the Gateway/IP-to-
IP application).
[7] IP-to-Tel = Filters according to a specified IP-to-Tel routing rule listed
in the Inbound IP Routing table (applicable only to the Gateway/IP-to-IP
application).
[8] IP Group = Filters according to a specified IP Group ID listed in the IP
Group table.
[9] SRD = Filters according to a specified SRD ID listed in the SRD
table.
[10] Classification = Filters according to a specified Classification rule
listed in the Classification table (applicable only to the SBC and
application).
[11] IP-to-IP Routing = Filters according to a specified SBC IP-to-IP
routing rule listed in the IP-to-IP Routing table (applicable only to the
Description
618
Mediant 3000
Document #: LTRT-89729