AudioCodes Mediant 3000 User Manual page 461

User's Manual

To configure IP-to-IP outbound manipulation rules:
1. Open the IP to IP Outbound Manipulation page (Configuration tab > VoIP menu >
SBC > Manipulations SBC > IP to IP Outbound).
2. Click the Add button; the following dialog box appears:
Figure 29-13: IP to IP Outbound Manipulation Page
3. Configure a rule as required. For a description of the parameters, see the table below.
4. Click Submit.
IP to IP Outbound Manipulation Table Parameters Description
Parameter
Matching Characteristics (Rule)
Additional Manipulation
[IPOutboundManipulati
on_IsAdditionalManipu
lation]
Source IP Group ID
[IPOutboundManipulati
on_SrcIPGroupID]
Version 6.6
Determines whether additional SIP URI user part manipulation is done
for the table entry rule listed directly above it.

[0] No = (Default) Regular manipulation rule - not done in addition to
the rule above it.

[1] Yes = If the previous table row entry rule matched the call,
consider this row entry as a match as well and perform the
manipulation specified by this rule.
Note: Additional manipulation can only be performed on a different SIP
URI (either source or destination) to the rule configured in the row above
(configured by the 'Manipulated URI' parameter).
Defines the IP Group from where the INVITE is received.
For any Source IP Group, enter the value -1.
461
29. SBC Configuration
- Add Dialog Box
Description
Mediant 3000