AudioCodes Mediant 3000 User Manual page 770

Parameter
]
Web/EMS: Line Build Out
Overwrite
[LineBuildOut.OVERWRITE]
Web/EMS: Line Build Out Loss
[LineBuildOut.Loss]
Web/EMS: Line Build Out
XPM0
[LineBuildOut.XPM0]
Web/EMS: Line Build Out
XPM1
[LineBuildOut.XPM1]
Web/EMS: Line Build Out
XPM2
[LineBuildOut.XPM2]
[TDMHairPinning]
Web: Enable TDM Tunneling
EMS: TDM Over IP
[EnableTDMoverIP]
User's Manual
trunk number.

[0] = Lock the trunk; stops trunk traffic to configure the trunk
protocol type.

[1] = shutting down (read only).

[2] = (Default) Unlock the trunk; enables trunk traffic.
Overwrites the Framer's XPM register values. These registers
control the line pulse shape.

[0] OFF = (Default) No overwrite.

[1] ON = Overwrite.
Defines the line build out loss for the selected T1 trunk.

[0] 0 dB (default)

[1] -7.5 dB

[2] -15 dB

[3] -22.5 dB
Note: This parameter is applicable only to T1 trunks.
Defines the Framer's XPM0 register value (line pulse shape
control).
The range is 0 to 255. The default is 0.
Note: This parameter is applicable only when the parameter
TrunkConfig.LineBuildOut.Overwrite is set to 1.
Defines the Framer's XPM1 register value (line pulse shape
control).
The range is 0 to 255. The default is 0.
Note: Applicable only when TrunkConfig.LineBuildOut.Overwrite
is set to 1.
Defines the Framer's XPM2 register value (line pulse shape
control).
The range is 0 to 255. The default is 0.
Note: This parameter is applicable only when the parameter
TrunkConfig.LineBuildOut.Overwrite is set to 1.
Defines static TDM hair-pinning (cross-connection) performed at
initialization. The connection is between trunks with an option to
exclude a single B-channel in each trunk.
Format example: T0-T1/B3,T2-T3,T4-T5/B2.
Note: For this parameter to take effect, a device reset is required.
Enables TDM tunneling.

[0] Disable (default)

[1] Enable
When TDM Tunneling is enabled, the originating device
automatically initiates SIP calls from all enabled B-channels
pertaining to E1/T1/J1 spans that are configured with the
'Transparent' protocol. The called number of each call is the
internal phone number of the B-channel from where the call
originates. The 'The Inbound IP Routing Table is used to define
the destination IP address of the terminating device. The
terminating device automatically answers these calls if its E1/T1
protocol is set to 'Transparent' (ProtocolType = 5).
Notes:
770
Description
Document #: LTRT-89729
Mediant 3000